Automatic copper foil cutting system lamination principle

1. After the mirror plate (leaves the washing machine) enters the clean room, the copper foil automatic cutting machine immediately cuts the copper foil of appropriate size and covers it on the mirror plate using a suction transfer machine (servo drive) to "ensure" that the mirror plate carries the least amount of contamination. Automatic copper foil cutting system

　　2. Use 2 copper foil automatic cutting machines, each with a double-type gripper and transfer machine (servo drive) to complete the (copper foil + mirror plate + copper foil) sandwich method, and complete the work in the automated, fast, safe and clean way.

　　Specification:

　　1. Working height: 900~1200 (depending on customer's plan).

　　2. Applicable mirror plate size: width 20"~45", length 26"~51" (depending on customer's plan)

　　3. Copper foil cutting accuracy: length difference ± 1 mm; diagonal difference ± 1 mm

　　4. Stacking mechanism positioning error ± 3 mm

　　Overlay features:

　　1. The lamination process uses an automatic "lower copper foil + mirror plate + upper copper foil" sandwich method to laminate and transport, reducing the risk of the mirror plate being contaminated by dust.

　　2. The lifting mechanism of the automatic stacking and gripping machine adopts "cam + servo" drive, which has smooth lifting and deceleration, accurate positioning, and reduces the air in the clean room.

　　Pollution caused by air turbulence.

　　3. Patented mechanism is available for purchase. Only the automatic copper foil cutting system needs to pre-stack and heat-rivet the inner layer outside the line to achieve full automation.

　　4. High lamination efficiency, the cycle can be set to 8~13 sec/cycle. (CCL fastest is 8 seconds)

　　5. The copper foil feeding adopts servo mechanism and tension control device. It can cut the release film. During the transportation process, there is no crease, dust pollution or scratch.

　　6. The contact surface between the fixture and the material is made of engineering plastic. The placement error is ￡ 1.5 mm.

　　7. The carrier plate is on the stacked lifting conveyor, with left and right correction and pressing functions, and dust collection ports are set around it (total dust collection air volume: recommended 15~25 CMM).

　　8. A counter for each group can be set.

　　9. Use touch screen to input data and set up the system.

　　10. The control of material input and output can be connected to the customer's control system.

　　11. The system controller can self-detect abnormalities such as action timeout, action failure or failure

　　Applicable to CCL factory copper foil substrate. In the clean room, the upper and lower copper foils, PP and stainless steel mirror plates are automatically stacked on the bottom plate in sequence and sent to the hot press machine for hot pressing.

　　After hot pressing, the copper foil substrate is sent to the disassembly table for automatic disassembly by the automatic copper foil cutting system, and the semi-finished products are stacked on the pallet.

　　Enter the clean room for lamination.

　　High yield and fast production speed - In OPEN, sixteen mirror plates and fifteen copper foil substrates are completed within 200 seconds.

　　Applicable copper foil: 1/3, 1/2, 1, 2 oz; PP: 1080, 2116, 7628. If you want to use 106, you must specify your needs.

　　Color touch screen operation, simple and convenient, abnormal information display instructions.

　　Size switching is pre-set on the touch screen, making switching simple and allowing for fine-tuning.

　　We specialize in producing automatic lamination reflow lines, lamination tables and transfer machines, automatic copper foil cutting systems, etc. Welcome to call us for consultation.